Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

F! & F2 window in basic positioner

Created by: innovations at: 6/3/2010 8:07 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/3/2010 8:07 AM	Rate (0)
innovations Experienced Member Joined: 5/21/2008 Last visit: 12/27/2024 Posts: 92 Rating: (0)	dear all, 1) what is function of f1 & f2 window in basic positioner. as far as i am cocerned if the difference between set & actual position is more than F1 & less than F2 window then r2620.2 is set once for measured value memory. pl. suggest whether this is correct or not? 2) i want to stop the axis ( set value = actual value )when itreached in between f1 & f2 window how to do it ? this i want to do by a measuring probe . pl. give your valuable sugestions

Suggestion To thank Quote Answer

6/13/2010 8:32 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 11/14/2024 Posts: 593 Rating: (64)	Hi. Can use is better FB283 then in the interface there is a signal, that the position is reached (Sollposition_erreicht). It is not necessary any windows F1 and F2. Windows are necessary, if a position contour to realise most. Best regards.

Suggestion To thank Quote Answer

6/13/2010 8:57 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 11/14/2024 Posts: 593 Rating: (64)	Hi. I have not found parametre r2620.2 There is a parametre p2620.2 Best regards. Attachment p2626.2.JPG (718 Downloads)

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_General

Follow us on