Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Failsafe Analogue Input Manipulation (336-4GE00-0AB0)

Created by: churroz at: 8/20/2013 7:47 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

8/20/2013 7:47 AM	Rate (0)
churroz Posts: 5 Rating: (0)	Dear Siemens Expertise, I have a Failsafe analogue input in my plant. The product number is 336-4GE00-0AB0. Several channel on the module are spare. In the diagnostic, these spare channel are considered as wire break. Is there anyway that we can manipulate this result? because we already know that the channel is a spare one. This is the first time I encounter failsafe module in my line of work. Kindly need your expert advise for this issue. Thank you
churroz Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

8/20/2013 9:45 AM	Rate (0)
miami Platinum Expert Joined: 8/31/2005 Last visit: 1/20/2025 Posts: 2198 Rating: (330)	Open in HW Config the properties of this board.In Parameters>Module Parameters you may deactivate not used channels (Set "Evaluation of the sensor" to "deactivated")

Suggestion To thank Quote Answer

12/19/2013 2:37 AM	Rate (0)
churroz Posts: 5 Rating: (0)	Thank You Miami
churroz Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

2/2/2016 10:52 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by dolbyinside is split to a separate thread with the subject Analog input module 336-4GE00-0AB0 pair channel problem. Best regards Min_Moderator

Suggestion To thank Quote Answer

3/10/2016 7:05 AM	Rate (0)
Saeed Bahadori Posts: 63 Rating: (8)	its beacuse failsafe output is normally close and you can disable wire break in hw config as expert say .
Saeed Bahadori Posts: 63 Rating: (8)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on