Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

FAQ: Reference data cannot be generated from an S7 project in 840Di

Created by: Ekalavya at: 6/19/2011 8:57 AM (1 Replies)

Rating (0)

Thanks 4

2 Entries

6/19/2011 8:57 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello, Enclosed FAQ gives us the information regarding 840Di Reference data cannot be generated from an S7 project. Regards, Ekalavya Attachment Reference data cannot be generated from an S7 project.pdf (125 Downloads)
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users PISCEAN 2010 VENKATESH

6/19/2011 9:16 AM	Rate (0)
umencho Diamond Member Joined: 3/21/2006 Last visit: 1/14/2025 Posts: 10239 Rating: (1182)	To mention here Cause: In the general project properties, the PCS 7 type was selected instead of STEP7. If you install Step7 from PCS7 DVD, this selection is done by default.

Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users PISCEAN 2010 VENKATESH

|

Share this page:

Share this page on...

Follow us on