Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Feedrate block

Created by: Testermax at: 10/18/2009 10:00 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

10/18/2009 10:00 AM	Rate (0)
Testermax Posts: 159 Rating: (3)	Hello! Is there any block in a library which calculates the feedrate (kg\h) based on the weight signal? Im going to build a PI controller where the user submits the feedrate i kg\h and the PI controller controls the Freq. conv. (0-100%) to the feeding motor.
Testermax Posts: 159 Rating: (3)	Last edited by: Testermax at: 10/18/2009 10:01 AM
Suggestion To thank Quote Answer

10/18/2009 2:18 PM	Rate (0)
Ayman Elotaify Platinum Expert Joined: 5/28/2008 Last visit: 6/4/2023 Posts: 4448 Rating: (827)	Dear Testermax I think the following FAQ link will help you. How can you accumulate physical flow measurements (e.g. mass flow rate, flow velocity) to an overall value? Best regards,
	Ayman Elotaify
Suggestion To thank Quote Answer

10/18/2009 6:19 PM	Rate (0)
Testermax Posts: 159 Rating: (3)	Hello Mr. Ayman Elotaify Thanx for quick reply. I extracted the step7 project (the .exe file) and imported the totalizer source code (external source i PCS 7) into my PCS 7 master library. When I tried to compile the source I got 4 errors. I only know SCL so I couldnt figure out what the error was. Do I miss some other blocks? To me it looks like there is a block call and that I havent got the other block. Attachment totalizer compile error.jpg (32 Downloads)
Testermax Posts: 159 Rating: (3)
Suggestion To thank Quote Answer

10/18/2009 8:39 PM	Rate (0)
Martin L Posts: 25 Rating: (2)	Hello there Testermax! From what I can tell it seems as a if a few errors have snuck in to the Totalizer_e source file. On the lines you're getting the errors, german STL mnemonics have been used. Try and replace the following: u #COM_RST; with A #COM_RST; spbn nw2; with JCN nw2; and BEa ; with BEU ; in both line 37 and 76 Hope this helps
Martin L Posts: 25 Rating: (2)
Suggestion To thank Quote Answer

10/18/2009 9:02 PM	Rate (0)
Testermax Posts: 159 Rating: (3)	Hellom Martin L Yes now it works! Thanx alot for the correction
Testermax Posts: 159 Rating: (3)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on