Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Fill level

Created by: gbs at: 9/29/2008 1:14 PM (5 Replies)

Rating (1)

Thanks 0

6 Entries

9/29/2008 1:14 PM	Rate (0)
gbs Posts: 178 Rating: (5)	Fill level properties - normally vertically from bottom to top. What I would like to do is fill from left to right. Can anyone advise. Thanks.
gbs Posts: 178 Rating: (5)
Suggestion To thank Quote Answer

9/29/2008 2:10 PM	Rate (0)
CBo Gold Member Joined: 4/5/2006 Last visit: 11/28/2024 Posts: 917 Rating: (63)	Hi gbs, only change geometry dinamically: use your tag to change "Width" properties (with calculate in "dinamic dialog") instead use it to fill your object. Regards

Suggestion To thank Quote Answer

9/29/2008 2:19 PM	Rate (0)
Khaled_Ezzat Silver Member Joined: 9/7/2007 Last visit: 10/9/2024 Posts: 550 Rating: (62)	Have you tried to rotate the object?
	Best Regards
Suggestion To thank Quote Answer

9/29/2008 3:56 PM	Rate (0)
gbs Posts: 178 Rating: (5)	I'm currently changing the width usig c script. Looking at doing it another way. In V7, fill pattern is similar to vista 3d look. Standard fill is bottom to top with no additional scripting. The object can be rotated however fill is still from bottom to top. Thanks,
gbs Posts: 178 Rating: (5)
Suggestion To thank Quote Answer

10/2/2008 10:32 AM	Rate (1)
Jaapie Gold Member Joined: 1/17/2006 Last visit: 11/22/2024 Posts: 800 Rating: (63)	Hi, I always use a "bar" when I want to make a fill level dynamic (left-right possible). Can this be used in your case? good luck, Jaapio

Suggestion To thank Quote Answer

10/2/2008 4:41 PM	Rate (0)
gbs Posts: 178 Rating: (5)	Thats what I have been looking for. Thanks.
gbs Posts: 178 Rating: (5)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on