Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

FM-350-2 counter value.

Created by: gordonene at: 12/3/2013 9:13 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

12/3/2013 9:13 AM	Rate (0)
gordonene Posts: 56 Rating: (2)	Hello, I want to use FM 350-2 for calculatin posistion of a object with A and B proxs. When I calibrated posistion wild I insert counting value to 50000 from counter card to avoid negative value. I have figure out you can reset counter value and set i to 0 by flip the software gate low and high again, but how can I set the counter value to 50000 manually?
gordonene Posts: 56 Rating: (2)
Suggestion To thank Quote Answer

12/3/2013 10:02 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 12/1/2023 Posts: 8596 Rating: (1140)	Hello hildrum, Here is a link to manual: SIMATIC S7-300 FM 350-2 Counter Module You can use FC CNT2_WR and the right job number to write the value to the counter. Best regards, Wizard

Suggestion To thank Quote Answer

3/14/2019 7:14 PM	Rate (0)
blmeye Posts: 8 Rating: (0)	Who would my FM-350 module start sending negative pules and going more negative?
blmeye Posts: 8 Rating: (0)	Last edited by: Jen_Moderator at: 3/15/2019 10:22:52 AM New subject after splitting Last edited by: Jen_Moderator at: 3/19/2019 6:08:22 AM Removed splitting remark.
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on