Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

FM-STEP DRIVE with Stepper Motor ??

Created by: Tomy Master at: 5/13/2011 11:22 PM (5 Replies)

Rating (0)

Thanks 1

6 Entries

5/13/2011 11:22 PM	Rate (0)
Tomy Master Gold Member Joined: 5/4/2009 Last visit: 5/28/2024 Posts: 914 Rating: (40)	Dear friends, Currently, I am trying to drive a stepper motor of type "1FL3041-0AC31-0BG0" by stepper motor drive of type "6SN1227-2EDI0-0HA0", but it seems like there is a problem, and the problem is that the "OV" and the "LV" leds are "ON" with solid red. I refer to the manual but it showed me that it could be a mains power problem dispite that mains power is OK !!!! Please I need some help. Tomy.
	Aim Higher
Suggestion To thank Quote Answer

5/14/2011 8:48 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (482)	Hello Tommy, OV menans Overvoltage or motor feedback energy too great....Reduce feedback energy of the motor or dissipate the feedback energy via the intermediate circuit connection. LV- Undervoltage -Adjust the voltage- Check mains voltage and mains connection As you have already checked the incoming supply could check the wire connections and the cable continuity properly which is connected to the FM stepdrive..... Also check the rotary switch settings properly...this need to be setted properly with according to your motor...you have the problem.... Check it out.... Regards, Ekalavya
Ekalavya Posts: 2964 Rating: (482)
Suggestion To thank Quote Answer

5/14/2011 9:50 AM	Rate (0)
Tomy Master Gold Member Joined: 5/4/2009 Last visit: 5/28/2024 Posts: 914 Rating: (40)	Dear Ekalavya, How can I reduce feedback energy, is it by rotary switch? Regards. Tomy.
	Aim Higher
Suggestion To thank Quote Answer

5/16/2011 6:56 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (482)	Hello Tomy, Check this document..... Regards, Ekalavya Attachment FBST_0205_en.pdf (426 Downloads)
Ekalavya Posts: 2964 Rating: (482)
Suggestion To thank Quote Answer

8/13/2012 3:13 PM	Rate (0)
nuk3 Posts: 1 Rating: (0)	I have same problem both LED lights are red OV and LV. I have a question I haven't connected power supply with mains filter could it be the case? Regards. Luke.
nuk3 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

9/21/2023 2:11 PM	Rate (0)
AutoGen_2331681 Joined: 9/21/2023 Last visit: 10/3/2023 Posts: 1 Rating: (0)	nuk3 I have same problem both LED lights are red OV and LV. I have a question I haven't connected power supply with mains filter could it be the case? Regards. Luke. I also encountered the same situation, it's been 10 years has anyone solved the problem yet @@ Update: My bad, need to supply 24V power to enable_n pin
	Last edited by: AutoGen_2331681 at: 09/22/2023 11:08:24
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Jen_Moderator

|

Share this page:

Share this page on...

Follow us on