Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

FM350-2 Start/End Value

Created by: clrhvc at: 7/5/2013 9:25 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

7/5/2013 9:25 AM	Rate (0)
clrhvc Posts: 7 Rating: (0)	Dear All, I want to ask about FM350-2 Counter Module. We can change start/end value of FM350-2 via hardware config but is it possible to change start/end value of FM350-2 using program? If it possible , can you explain how to change it? Best Regards, Clrhvc
clrhvc Posts: 7 Rating: (0)	Last edited by: clrhvc at: 7/5/2013 9:25 AM
Suggestion To thank Quote Answer

7/6/2013 5:57 PM	Rate (0)
Ayman Elotaify Platinum Expert Joined: 5/28/2008 Last visit: 10/3/2023 Posts: 4478 Rating: (830)	clrhvc Dear All, I want to ask about FM350-2 Counter Module. We can change start/end value of FM350-2 via hardware config but is it possible to change start/end value of FM350-2 using program? If it possible , can you explain how to change it? Best Regards, Clrhvc Hello, I did not tried this before, but in thismanual(section 6.5) you can found a solution using FC_CNT2 (Write Job). You can change load low limit and hifgh limit for all 8 counters of FM350-2. Hope this helps.
	Ayman Elotaify
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on