Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

fm354 m acknowledge

Created by: mhan at: 6/9/2011 6:42 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/9/2011 6:42 AM	Rate (0)
mhan Member Joined: 12/7/2009 Last visit: 5/8/2024 Posts: 12 Rating: (0)	dear expert! i want to ask the function of m acknowledge in FM 354. i used pulsing to set reset the bit of the DBX15.4 for m function...in first 12 steps the motor hit the proper position, after the 1 batch of operation the logic has satisfy and the m acknowledge was activated, but the motor did not run and stack on last position eventhough the m acknowledge has been activated...my i please seek your view about my problem,thanks and best regards!!! emman

Suggestion To thank Quote Answer

6/9/2011 7:32 PM	Rate (0)
KayBee Posts: 241 Rating: (7)	Hi, mhan, You can find FM354 related some issue here. I think you need to re-check all the paramteers and your plc logic.
KayBee Posts: 241 Rating: (7)
Suggestion To thank Quote Answer

6/10/2011 3:02 AM	Rate (0)
mhan Member Joined: 12/7/2009 Last visit: 5/8/2024 Posts: 12 Rating: (0)	thanks powertags...

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on