Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

FM354 Problem

Created by: Wandrey at: 6/23/2010 7:50 PM (5 Replies)

Rating (2)

Thanks 0

6 Entries

6/23/2010 7:50 PM	Rate (0)
Wandrey Posts: 36 Rating: (1)	Afriend of mine got a problem on FM 354. When positioning the DB block shows on DBX22.3 an OT-Error? This OT Error is a Siemens problem or its a machine manufactor problem? Tks
Wandrey Posts: 36 Rating: (1)
Suggestion To thank Quote Answer

6/23/2010 8:49 PM	Rate (2)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 9/10/2024 Posts: 10228 Rating: (1181)	Hello, Look at Error evaluation for FM353 / FM354 in the user program There you'll find the answer. best regards, Hristo Mihalev

Suggestion To thank Quote Answer

6/24/2010 1:29 PM	Rate (0)
Wandrey Posts: 36 Rating: (1)	Tkx for the answer UMENCHO, but unfornately the eletricians had turned off the machine and then turn on and the fail disappers. So they haven´t see the valeu of DBB90. Anyway thanks again for your help! Best Regards, Wandrey
Wandrey Posts: 36 Rating: (1)
Suggestion To thank Quote Answer

7/6/2010 10:34 PM	Rate (0)
Wandrey Posts: 36 Rating: (1)	The error shows up again, but this time they saw whats on DB154 DBB90 and 91 DBB90 - 03h (03d) DBB91 - 41h (65d) On page 11 - 21 of the manual: No drive movement Cause: - axis standstill at maximum drive control signal (+-10v) - on violation of the defined following error limit Effect: - Deceleration of the drive via voltage ramp (MD45) - Actual value transfer (internally like "follow-up mode") Elimination: - Check drive / connecting cables - Check controller enable signal between FM and drive The eletricians turned off and turned on agains the machine, that´s why they can´t checkthe fail. More information on the next chapters
Wandrey Posts: 36 Rating: (1)
Suggestion To thank Quote Answer

6/26/2017 5:55 PM	Rate (0)
surya the great Member Joined: 4/23/2016 Last visit: 8/22/2021 Posts: 1 Rating: (0)	i am having transverse error in this module fm354 max limit reached what should i do
	Last edited by: surya the great at: 6/26/2017 6:16:35 PM
Suggestion To thank Quote Answer

1/15/2018 10:45 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (171)	New question published by Thibaut V is split to a separate thread with the subject FM 354 G91 relative mode - Get POS_REACHED= TRUE even if difference between setpoint and actual position is bigger than PM24. Best regards Jen_Moderator
	Last edited by: Jen_Moderator at: 1/15/2018 10:49:26 AM Inserted right headline.
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on