Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

From technosoft to siemens

Created by: PaulKeizer at: 10/1/2012 9:01 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

10/1/2012 9:01 PM	Rate (0)
PaulKeizer Posts: 19 Rating: (1)	Hello everyone, Someone asked my to help with his machine. This is a machine made by someone who doesn't want to help with this machine, because the company is bankrupt. This machine is controlled by a rabit board or something like that. I want to change the controller by a et200s from siemens. And i am a little used to program this so this should be no problem. But also on this machine there are some servo drives from technosoft and i also want to change this for siemens components. But i never worked with siemens drives so i am completely new to this. But is it possible to use siemens drives with the already installed motors and encoders from technosoft? Thanks.
PaulKeizer Posts: 19 Rating: (1)
Suggestion To thank Quote Answer

11/13/2012 12:27 PM	Rate (0)
Bilao Posts: 378 Rating: (47)	Hello, i think for this question it is better to ask the siemens guys in your region. Contacts Worldwide Best regards Bilao
Bilao Posts: 378 Rating: (47)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_General

Follow us on