Navigation

"Function not permitted in current protection level"

Created by: Peter S at: 6/29/2011 8:51 PM (1 Replies)

6/29/2011 8:51 PM	Rate (0)
Peter S Posts: 6 Rating: (0)	Hey, I am trying to debug a LAD FB for Step 7 by using breakpoints. But after I open it online, whenever I try to place a break point I get the message, "Function not permitted in current protection level". I have been trying to find out about how to change the protection level but nothing is working. Any insight? Splitted from Step 7 Access Protection.
Peter S Posts: 6 Rating: (0)	Last edited by: O_Moderator at: 6/30/2011 10:14 AM new subject after splititng
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users shawn allen

6/29/2011 9:49 PM	Rate (1)
hdhosseini Diamond Expert Joined: 1/28/2009 Last visit: 5/26/2023 Posts: 6802 Rating: (1345)	Peter S Hey, I am trying to debug a LAD FB for Step 7 by using breakpoints. But after I open it online, whenever I try to place a break point I get the message, "Function not permitted in current protection level". I have been trying to find out about how to change the protection level but nothing is working. Any insight? Check if your CPU is in RUNP. Regards
	Demo Channel on Youtube
Suggestion To thank Quote Answer