Navigation

G120C: need help with terminal control and parameter settings

Created by: Jappdu at: 12/9/2020 11:03 PM (1 Replies)

12/9/2020 11:03 PM	Rate (0)
Jappdu Posts: 1 Rating: (0)	G120c canot use on both analog and fixed speed .i tried all macro settings 6 to 20 but it is working only either fixed nor automatic so please support me about this terminal control and parameter settings ------------------------------------------------------------------------------------------ Split from Can't run sinamics g120 over terminal control ???.
Jappdu Posts: 1 Rating: (0)	Last edited by: The Helping Hand at: 12/10/2020 17:01:35 New subject after splitting
Suggestion To thank Quote Answer

12/10/2020 4:52 PM	Rate (0)
0_Einstein Diamond Member Joined: 7/7/2010 Last visit: 1/17/2025 Posts: 15541 Rating: (2465)	Is there a spare digital input available you can use to switch between fixed or analog? If the input is ON, use analog input for speed setpoint. If the input is OFF, use fixed setpoint, or perhaps a set of DI's for setpoint selection. Jappdu G120c canot use on both analog and fixed speed .i tried all macro settings 6 to 20 but it is working only either fixed nor automatic so please support me about this terminal control and parameter settings
	science guy
Suggestion To thank Quote Answer