Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

gear change

Created by: munarza at: 11/5/2009 10:16 AM (2 Replies)

Rating (0)

Thanks 2

3 Entries

11/5/2009 10:16 AM	Rate (0)
munarza Posts: 30 Rating: (1)	Hello, we have a machine that is controlled by a 840Di and there are four gear stages. could anyone know about how can automatic gear changing done on this machine because i know that sinumerik allows five gear stages but in axis datablock there are 3 stages enabled ( db3yy.dbx82.0, dbx82.1 dbx82.2 ). How can i program the fourth gear stage because there is no automatic gear request like 82.0, 82.1 , 82.2 ... Could anyone help on this matter it will be very precious. thanks
munarza Posts: 30 Rating: (1)
Suggestion To thank Quote Answer

11/5/2009 11:23 AM	Rate (0)
Pee Ell Sea Posts: 672 Rating: (57)	Hi, Not sure whether you are asking as an end user or developer. Automatic gear range selection is via G40 in the part program Bits 82.0/1/2 are binary coded
Pee Ell Sea Posts: 672 Rating: (57)
Suggestion To thank Quote Answer

11/6/2009 12:58 AM	Rate (0)
CNC600 Silver Member Joined: 10/27/2009 Last visit: 3/15/2024 Posts: 455 Rating: (77)	The current gear step has to be provided by PLC in DB(AX).DBX16.0..2 the requested gear step will be shown by CNC in DB(AX).DBX82.0..2 in both areas the gearsteps will be displayed in binary mode! By programming M40 You can select the automatic gear change By programming M41...M45 You can select therequested gear changemanualy Before You can use the gear change anywayYou have to activate the gear step change by - MD 35010 GEAR_STEP_CHANGE_ENABLE and - You have to set the corresponding data for gear step speed limitations $MA_GEAR_STEP_MAX_VELO and $MA_GEAR_STEP_MIN_VELO. hope that helps CNC600
	hope that helps CNC600
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users IBN-Service mehar

|

Share this page:

Share this page on...

Follow us on