Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Hard disk ghost backup for SINUMERIK 840C controller

Created by: Controls_Engineer at: 12/30/2008 10:46 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

12/30/2008 10:46 AM	Rate (0)
Controls_Engineer Posts: 60 Rating: (1)	Dear people, I have a turning machine with 840C controller. In this i would like to take ghost image back for the hard disk (the one fixed in the MMC CPU module). Can i take the hard disk out of the module and connect it in any PC as slave then take ghost image backup??? Is it a right method or not ?? Pls your advice on this.. Thanks, Venki
Controls_Engineer Posts: 60 Rating: (1)
Suggestion To thank Quote Answer

12/30/2008 11:09 AM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi Yes you can do it and it's OK. Nit

Suggestion To thank Quote Answer

12/30/2008 11:14 AM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Dear Sir The use of ghost to backup of 840C is not recommended. The correct method is to a software package called PcLink and Interlink. This is available from your local Siemens service office. Regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

12/30/2008 11:21 AM	Rate (0)
Controls_Engineer Posts: 60 Rating: (1)	Dear M.Steve, Thanks for your reply. Can I get this pclink software in net???
Controls_Engineer Posts: 60 Rating: (1)
Suggestion To thank Quote Answer

12/30/2008 12:25 PM	Rate (0)
Gebhardt Karl Platinum Expert Joined: 7/16/2006 Last visit: 1/2/2024 Posts: 1502 Rating: (176)	Turn Main-Power off. Remove the Harddisk. Take an USB-2,5 Zoll-Adapter. Make an Image with an "normaly" PC. Ready
	Last edited by: Gebhardt Karl at: 12/30/2008 12:26 PM Karl
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on