Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Hidden Free Function Blocks

Created by: Mircea3M at: 10/12/2018 2:35 PM (3 Replies)

Rating (0)

Thanks 2

4 Entries

10/12/2018 2:35 PM	Rate (0)
Mircea3M Bronze Member Joined: 1/3/2013 Last visit: 11/27/2023 Posts: 40 Rating: (3)	Dear friends, I have the following configuration: G120 CU250S-2PN which I just upgraded to 4.7.11 G120 PM240-2 1LE1 motor Starter version is 5.1.1.2 and an additional software package was installed to match the 4.7.11 firmware of the CU250S. I have a start and stop push-buttons, and I would like to use a RSR function and the result to connect it to the On/Off 1 signal...but I cannot find the free function blocks. Am I missing something? Please let me know if you have any advice. Best regards!

Suggestion To thank Quote Answer

10/12/2018 3:03 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 12/4/2023 Posts: 5716 Rating: (771)	Hello, please have a look at chapter 6.14 of the operating manual of the CU250S-2. https://support.industry.siemens.com/cs/ww/en/view/109757229/
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Mircea3M

10/12/2018 4:50 PM	Rate (0)
Yu-wen Tang Silver Member Joined: 10/7/2009 Last visit: 8/19/2023 Posts: 266 Rating: (88)	Dear Mircea3M, You must first enable the Free Function Blocks in the Control Unit > Configuration > Wizard… Please see the attached picture. Best regards, Yu-wen Attachment Free Functin Block.png (108 Downloads)

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Mircea3M

10/13/2018 9:36 AM	Rate (0)
Mircea3M Bronze Member Joined: 1/3/2013 Last visit: 11/27/2023 Posts: 40 Rating: (3)	Hello again, this is a very funny situation...I've recreated several times the project using Starter just to be sure that I am not missing something....and there they were. Being my first project with Starter and G class VSDs, i thing that not knowing the terminology was one of the issues. Thanks again Technology Team and Yu-wen. Best regards

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_G

Follow us on