Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

High Feature and Standard AI Modules

Created by: egy_eng at: 6/24/2012 12:54 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

6/24/2012 12:54 PM	Rate (0)
egy_eng Posts: 43 Rating: (0)	hello all , ihope that you are all fine i will get into the point i have two question first i need to know what is the difference between the high feature modiles and the standard modules and what is the meaning of high feature ? second i have HF AI modules with P.N ( 6ES7134-4LB02-0AB0) and i want to replace it by the Following Standard AI module with P.N ( 6ES7134-4GB00-0AB0) is that possible or not ? if no , why ? if yes , will it affect the process?? thanks for your efforts regards
egy_eng Posts: 43 Rating: (0)
Suggestion To thank Quote Answer

6/24/2012 10:42 PM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 6/1/2023 Posts: 12030 Rating: (2594)	Hello egy_eng; Here is a FAQ that describes High-Feature modules: New ET 200S High Feature Analog Modules with 0.5ms Cycle Time Released for Delivery The following new functions were introduced: Significantly faster cycle time of 0.5ms per module Support of isochrone mode (interface module and DP master or PN IO controller must also support this function) Support of I&M data (Identification & Maintenance, (interface module and DP master or PN IO controller must also support this function)) Process interrupt; If the upper or lower limiting values are exceeded (limiting values are freely parameterizable) If your system uses any one of these features you cannot replace the AI modules with an earlier version. Hope this helps, Daniel Chartier
	Last edited by: dchartier at: 6/24/2012 10:43 PM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on