Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

High Speed Counter

Created by: MIRI at: 10/22/2011 9:20 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

10/22/2011 9:20 PM	Rate (0)
MIRI Posts: 7 Rating: (0)	Hello I've got a question for High Speed Counter. I'm little new to this program and when I use a HSC I don't know where to set those values for example NEW_RV that has a limit -2312313 to 212313 something like that. I hope you understand the question and thanks.
MIRI Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

10/24/2011 11:50 AM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 12/6/2023 Posts: 4282 Rating: (1380)	Hi, a HSC represents its counter value as a double integer with sign. That means that the couter value go from -2.147.483.648 to +2.147.483.648. You can work in a sub set of this range, reseting or load new count value in your user program. You can configure, for example, a HW interruption, based in a comparation value. In the Interrupt OB, you can load a new counter value with HSC_CTRL
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

10/25/2011 11:47 PM	Rate (0)
MIRI Posts: 7 Rating: (0)	Thanks for your reply but could you show me a little example cause I couldn't find one.
MIRI Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

10/27/2011 11:52 AM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 12/6/2023 Posts: 4282 Rating: (1380)	Hi, here is a example (not tested). It should runs between 0 and 100. If you test the solution like propouse, please post the results. Attachment Example.zip (306 Downloads)
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

11/13/2011 1:56 AM	Rate (0)
MIRI Posts: 7 Rating: (0)	Ok I tried this but something iswrong again anybody else tried it ? Thanks Pegaia
MIRI Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on