Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

HIGRAPH with STL

Created by: 149484 at: 4/10/2013 4:06 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

4/10/2013 4:06 AM	Rate (0)
149484 Posts: 5 Rating: (0)	Hi, I have a s7 program use HIGRAPH langrage but when I open it, I can only see STL. How can I transfer it to HIGRAPHlangrage?tks.
149484 Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

4/10/2013 7:59 AM	Rate (0)
Marcjan Platinum Member Joined: 4/22/2010 Last visit: 12/15/2022 Posts: 5697 Rating: (702)	Hello, For that you need additional software Highgraph. Regards, Marcjan
	Problem solved? Please let us know! Please no technical questions by PM, use the forum sections for your questions.
Suggestion To thank Quote Answer

4/12/2013 4:38 AM	Rate (0)
149484 Posts: 5 Rating: (0)	Hello,Marcjan thanks for your replay, I have already install Higraph, I think maybe the project miss the files in the sources folder. Anyone know howtorepair theproblem? Regards,
149484 Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

4/23/2013 9:40 AM	Rate (0)
Cicero Gold Member Joined: 10/10/2005 Last visit: 3/16/2023 Posts: 1909 Rating: (131)	Hello, have you loaded your project after the installation of HiGraph or befor you have installed the HiGraph. In this case repeat this step again: Load your project in the SIMATIC Manager (after installation). The files of HiGraph should be in the sources folder. With best regards Cicero

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on