Here is error during online when I try create new HMI Connection

Faizalromli

Hi all,

A finding that I found today.

Under Connection tab, new connection cannot be done to set between WinCC and PLCSIM,

See at my "connection 1",there is no partner name(PLC_1) which is the PLCSim PLC, this Partner name also cannot be entered manually

What I done is that go to HMI Tag -->Default Table Tag, then Add new tag,

Then add every details including PLC Tag, this will auto generate the connection under "HMI Connection_1"

If there is no "HMI Connection_1" created,

Then need to stop PLC at PLCSim and set PLC at TIA Portal to offline and retry, New "HMI_Connection_1" cannot be done during online as there is error

Hope it help

Regards,

Faizal

rik452

Hello,

I am new to this forum and just installed TIA Portal V15! But I can't seem to figure out how to connect WinCC RT to my PLCSIM! I'm trying to make a HMI which controls factory I/O to simulate a factory! This is all on one pc! Could someone help me out? I am rather new to TIA portal/Siemens overall!

 

------------------------------------------------------------------------------------------
Split from TIA Portal V15 -> PLCSIM Advanced 2.0 -> WinCC RT.

 Hi there,

I think this post should be solved.

thank by the way

itafusna

Hi Faizalromli,

Let's see...

In the hardware configuration of the project, have you networked both devices and, subsequently, have you defined the HMI connection?

What communication protocol does the PLC have? and the HMI?