Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

hmi problem

Created by: bhautik at: 3/21/2013 8:37 AM (5 Replies)

Rating (0)

Thanks 1

6 Entries

3/21/2013 8:37 AM	Rate (0)
bhautik Posts: 17 Rating: (0)	Good Morning Everyone I am using comfor 7inch hmi panel in my project. I am quiet new to automation (plc + hmi) field. I faced quiet a problem. 1) When I trasferred my tags from the default tag table to a new tag talel and there after cleared the default tag table. But when I started the simulation the software asked to close or restart 2) When I was configuring the analog alarm for the first time, after configuring alarm as mentioned in Configuration of Messages andAlarms in WinCC (TIA Portal) when I started the simulation, the software again asked for restart or close option. I guess it complied 100% as I was able to see it in the background but then it prompted for only restart or close option. What could be the possible cause of the problem and how it can be resolved?
bhautik Posts: 17 Rating: (0)
Suggestion To thank Quote Answer

3/21/2013 9:07 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 1/15/2025 Posts: 8804 Rating: (1173)	Hello bhautik, Try to compile (Rebuild all) Select panel -> Right mouseclick -> Compile -> Software (rebuild all) Best regards, Wizard

Suggestion To thank Quote Answer

3/21/2013 9:37 AM	Rate (0)
bhautik Posts: 17 Rating: (0)	Thank you Wizard. I did what u suggested and was able to solve the problem but can you tell me what is the difference between the option that comes in the compile option? I mean what do they do? once again thank you for the support Bhautik
bhautik Posts: 17 Rating: (0)
Suggestion To thank Quote Answer

3/21/2013 9:52 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 1/15/2025 Posts: 8804 Rating: (1173)	Hello bhautik, Great, you solved the problem. When you compile the project, the changes detected by the software are compiled. (So this is quicker) When you compile (Rebuild ALL), you will compile the whole project. It will take a longer time. But everything is checked. And found problems will be solved. Advise is to use the Compile (Rebuild ALL) more often. Best regards, Wizard

Suggestion To thank Quote Answer

3/21/2013 10:15 AM	Rate (0)
bhautik Posts: 17 Rating: (0)	Thank you Wizard for the support I will surely keep a note of your suggestion. Bhautik
bhautik Posts: 17 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Wizard

3/23/2015 9:20 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by firasSiemens is split to a separate thread with the subject TIA V12, i can't open or create new screen. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Installation Options General

Follow us on