Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

HMI Sim not communicating

Created by: JenIRL at: 9/10/2012 1:02 PM (3 Replies)

Rating (1)

Thanks 1

4 Entries

9/10/2012 1:02 PM	Rate (0)
JenIRL Posts: 5 Rating: (0)	Hi, I'm a newbie so bear with me...much more at home with AB stuff. I'm playing with an S7-1200, PLC & HMI programs in TIA v11. I want to simulate the HMI butit won't communicate(#### instead of values and PLC not seeing buttons being pressed). I can go online to the PLC no prob. Is it something really simple and obvious?? Please?
JenIRL Posts: 5 Rating: (0)
Suggestion To thank

9/10/2012 2:06 PM	Rate (1)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 1/27/2023 Posts: 13080 Rating: (2123)	JenIRL Hi, I'm a newbie so bear with me...much more at home with AB stuff. I'm playing with an S7-1200, PLC & HMI programs in TIA v11. I want to simulate the HMI butit won't communicate(#### instead of values and PLC not seeing buttons being pressed). I can go online to the PLC no prob. Is it something really simple and obvious?? Please? Normally it is simple. Windows Control Panel -> Set PG/PC Interface and select the network adapter you want to use for HMI simulator. When that does not work, it generally means the language of your project is not matched with the portal defaults. In the project tree, find the language area near the bottom of the project tree and make the proper selection(s) to match your needs.
	science guy
Suggestion To thank
This contribution was helpful to 1 thankful Users JenIRL

9/10/2012 3:26 PM	Rate (0)
JenIRL Posts: 5 Rating: (0)	Thank you!
JenIRL Posts: 5 Rating: (0)
Suggestion To thank

9/11/2012 8:22 AM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 1/20/2023 Posts: 2685 Rating: (135)	Thread closed, because question is already discussed in the following thread can't simulate / run HMI Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on