Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

HMI simulation s7-1200

Created by: infirio at: 9/4/2009 6:44 PM (5 Replies)

Rating (1)

Thanks 1

6 Entries

9/4/2009 6:44 PM	Rate (0)
infirio Posts: 3 Rating: (1)	Hi I have an starter kit s7-1200. This kit includes a plc and I was wondering if I can connect this plc to my computer and with the step7 simulate a basic panel. I have tried this many times but the only thing i can do is run a simulator for the tags not with the real tags from the plc. Can somebody helpme?
infirio Posts: 3 Rating: (1)
Suggestion To thank Quote Answer

9/7/2009 9:14 AM	Rate (0)
Robster Gold Expert Joined: 5/28/2008 Last visit: 5/15/2023 Posts: 1343 Rating: (139)	Hi, Step 7 Basic includes a WinCC flexible 2008 Runtime. With this, you can simulate the Panel on your PC. To do this, you have to adjust your PG/PC interface in system settings of your PC. Configure the access point S7ONLINE with TCP/IP Network adapter of your PC. Then click to your HMI in Step7 Basic projekt and start the runtime by clicking on the green arrow symbol bar on top. Good luck

Suggestion To thank Quote Answer

9/8/2009 2:15 AM	Rate (0)
zumpafust Posts: 4 Rating: (0)	Hello, I am having the same problem. Is there a manual that describes how to use the RT Simulator with STEP 7 Basic? Thanks
zumpafust Posts: 4 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users popciprian75

9/8/2009 2:40 AM	Rate (1)
infirio Posts: 3 Rating: (1)	Hi thank you for your help. Problem solve it. The only thing I needed to do was entering to control panel and configure on SET PG/PC INTERFACE the TCP/IP.
infirio Posts: 3 Rating: (1)
Suggestion To thank Quote Answer

9/8/2009 10:43 AM	Rate (0)
Robster Gold Expert Joined: 5/28/2008 Last visit: 5/15/2023 Posts: 1343 Rating: (139)	zumpafust Hello, I am having the same problem. Is there a manual that describes how to use the RT Simulator with STEP 7 Basic? Thanks There is no manual. Please have a look to the thread I posted yesterday. Directly above yours

Suggestion To thank Quote Answer

11/8/2015 9:06 AM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 5/24/2023 Posts: 4099 Rating: (192)	New question published by Manvydas is split to a separate thread with the subject HMI simulation s7-1200 Tia V13. Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on