Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Honeywell 6300 scanner to Et200s ASCII error

Created by: G_H at: 4/6/2009 6:20 PM (1 Replies)

Rating (0)

Thanks 1

2 Entries

4/6/2009 6:20 PM	Rate (0)
G_H Posts: 54 Rating: (0)	HelloI have a serial card (6ES7 138-4DF01-0AB0) and have a Honeywell 6300 series DPM scanner connected (simple wiring Tx/Rx/Ground) I am using FB2 (S_RECV_SI) and each time I scan the Rx light flashes and I get error status W#16#0811. I can connected to my PC serially and receive ok via hyper terminal so I know the baud rate etc are ok.Any ideas?, the error code suggested settings/wiring but I think this is all OK? Many thanks
G_H Posts: 54 Rating: (0)	Last edited by: G_H at: 4/6/2009 6:20 PM
Suggestion To thank Quote Answer

4/6/2009 7:36 PM	Rate (0)
G_H Posts: 54 Rating: (0)	ok problem sorted, Honeywell gave me the wrong RS232 pinout colours! wasted 2 days on this!
G_H Posts: 54 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users UMENCHO

|

Share this page:

Share this page on...

Follow us on