How received "profibus from drive" data must be scaled at PLC?

Hi guys,

i need to exact how received "profibus from drive" data (with map specified at 7-15 table) must be scaled at PLC:  "fraction part offset"/scalar & Phy units?

will4

Please find the communication manual in the link below

Section 6.7 talks about the GSD files.

Note: The Profibusmaster must be configured to have the same quantity of Bytes that are set by the parameter ‘Network I/O Size’ (9951) to communicate with the Siemens NXG drive.

Attachment

NXG_Communications_manual_A5E02924901A_ver_AA.pdf(396 Downloads)

------------------------------------------------------------------------------------------
Split from Robicon PH profibus.