How to changed F1910 into a message?

Hi every body

How to changed F1910 into a message ?

Thank you

------------------------------------------------------------------------------------------
Split from Sinamics G130, CU320, AOP30 Fault F1910 PB Setpoint timeout in local operation with AOP30.

Gary.Hare

F1910 will appear if the drive sees bit 10 in the control word go from high to low. (expected if the plc is switched off). If you reset this fault the drive should run in local with no problems.
If the fact that the fault is occuring in the first place is the problem, you can change F1910 into either an alarm or just amessage so you will not need to reset it at all. - P2118 & P2119

 The Clue is in the post Dude!