Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

how to changeover from SMC10 with resolver to SMC30 with encoder

Created by: Liuyongtao at: 6/5/2011 5:53 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

6/5/2011 5:53 AM	Rate (0)
Liuyongtao Posts: 6 Rating: (0)	My project is that one VECTOR drive connect to two motors.Two motors ischangeovered by contactor.One of motor is built-in resolver via SMC10 to driverand another motor is built-in HTL encoder via SMC30 to driver.and EDS can be configurate in Starter ? When motor was changeovered, how I change the actspeed r0063 from SMC10 to SMC30? your reply will be helpful,thanks!
Liuyongtao Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

6/5/2011 9:47 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 9/2/2024 Posts: 591 Rating: (64)	Hi. You create two sets of CDS. One set for the motor with a sensor SMC10, a second set for a motor with a sensor SMC30. You switch the CDS data sets and r63 are the corresponding sensor. Switching sets in the absence of p840. Best regards.

Suggestion To thank Quote Answer

6/6/2011 9:28 AM	Rate (0)
viralpatel Silver Member Joined: 11/18/2010 Last visit: 8/5/2022 Posts: 523 Rating: (32)	you can reconfigure drive object in scout or starter. by configure DDS under drive configuation option. viral patel

Suggestion To thank Quote Answer

6/6/2011 2:44 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 9/2/2024 Posts: 591 Rating: (64)	viralpatel you can reconfigure drive object in scout or starter. by configure DDS under drive configuation option. viral patel Hi. viralpatel rights. Sinamics drive can work with three encoders (EDS). Switching between the encoders (choise EDS) - it's in my correct. Best regards.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on