Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

How to configure p2000-p2004 in motor changover application GM 150

Created by: changP at: 1/1/2015 2:14 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

1/1/2015 2:14 PM	Rate (0)
changP Member Joined: 7/5/2010 Last visit: 10/18/2023 Posts: 16 Rating: (0)	Dear Expert, This drive is operating with two motors so called motor changeover application. Whenwe change over one motor to another motor the reference parameter p2000-p2004 are not changing to another motor. It would be great if you can advise how to configure the reference value p2000-p2004 in order to change accordingly when selecting different MDS. Best regards, Peter

Suggestion To thank Quote Answer

1/4/2015 2:40 PM	Rate (0)
Attia Posts: 37 Rating: (0)	Hello you set parameter P0130(Number of Motor Data Sets (MDS) / MDS count). If Used Two Motor Must Set P0130=2
Attia Posts: 37 Rating: (0)	Last edited by: Attia at: 1/4/2015 2:42 PM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_MediumVoltage

Follow us on