Navigation

how to display the diagnostic buffer messages directlly in hmi(840d)

Created by: karthik_sapl at: 4/30/2009 8:58 AM (1 Replies)

4/30/2009 8:58 AM	Rate (0)
karthik_sapl Posts: 7 Rating: (0)	is that possible to display the plc`s diagnostic buffer messages directlly in hmi, if so plese tell the procedure. thanking you. yours karthik
karthik_sapl Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

4/30/2009 6:40 PM	Rate (0)
Pee Ell Sea Posts: 672 Rating: (57)	Hi, The only way I know is to load Step 7 onto the HMI.
Pee Ell Sea Posts: 672 Rating: (57)
Suggestion To thank Quote Answer

Share this page:

Share this page on...