Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

How to send commands?

Created by: alPAVESI at: 3/30/2021 4:34 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

3/30/2021 4:34 PM	Rate (0)
alPAVESI Regular Member Joined: 7/2/2015 Last visit: 12/13/2024 Posts: 1 Rating: (0)	Bom dia Denilson, td bem? Apenas uma duvida, sempre pensando como sao os faceplates do WInCC antigo, eu sempre utilizo botoes e switchs dentro dos faceplates, e com o Unified ele nao habilita o seu uso, apenas atraves de scripts. É possivel mandar comandos utilizando esses controles e não ser apenas para visualizações? obrigado! ------------------------------------------------------------------------------------------ Split from WinCC Unified – TIP’s for Faceplate.
	Last edited by: Jen_Moderator at: 03/31/2021 07:50:07 New subject after splitting
Suggestion To thank Quote Answer

3/31/2021 7:52 AM	Rate (0)
Jen_Moderator Diamond Member Joined: 6/19/2017 Last visit: 9/6/2024 Posts: 8175 Rating: (174)	Hi alPAVESI, Please try to discuss your question in English language. This is an international community and we try to focus on one language. Posting in English will help you to get more response to your question. This is the translation of your question: alPAVESI Good morning Denilson, how are you? Just a doubt, always thinking about what the old WInCC faceplates look like, I always use buttons and switches inside the faceplates, and with Unified it does not enable its use, only through scripts. Is it possible to send commands using these controls and not just for visualizations? thank you! Regards, Jen_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on