Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

How to use SFB52 for SCALANCE ?

Created by: yuvalg at: 5/28/2010 11:06 AM (3 Replies)

Rating (0)

Thanks 1

4 Entries

5/28/2010 11:06 AM	Rate (0)
yuvalg Posts: 8 Rating: (0)	Hello, Can someone please explain or give a short example how to use the SFB52 in order to diagnose SCALANCEs units on PN network ? I don't fully understand (maybe folly ) its necessary parameters (Index, ID, etc) Thanks and have a nice day Yuval
yuvalg Posts: 8 Rating: (0)	Last edited by: yuvalg at: 5/28/2010 11:37 AM
Suggestion To thank Quote Answer

5/31/2010 8:40 AM	Rate (0)
little holmes Experienced Member Joined: 12/9/2009 Last visit: 4/18/2024 Posts: 156 Rating: (11)	Hello, here is a sample program and description for SFB52. Maybe it helps you. http://support.automation.siemens.com/WW/view/en/38566021 Good Luck Little Holmes

Suggestion To thank Quote Answer

5/31/2010 10:20 PM	Rate (0)
yuvalg Posts: 8 Rating: (0)	Thanks very much little holmes ! From a first glance this is exactly what I were looking for ! All the best yuvalg
yuvalg Posts: 8 Rating: (0)	Last edited by: yuvalg at: 5/31/2010 10:23 PM Last edited by: yuvalg at: 5/31/2010 10:22 PM
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users S_Moderator

5/23/2017 4:56 AM	Rate (0)
Alumi Posts: 23 Rating: (0)	Hi Sir : I use S7-300 cpu 315-2 PN/DP to connect my profinet IO device. I can connect IO device successfully. Now, I try to use SFB52(RDREC) to read record data and use below codes. L W#16#1234 // Record index --> I am not sure since I check my GSDML of my IO device // Because there are couple record index T MW 100 CALL "RDREC", DB52 REQ := M0.5 ID := DW#16#7FA // Diagnostic address of my IO device MLEN := 2 VALID := M110.0 BUSY := M110.1 ERROR := M110.2 STATUS := MD112 LEN := MW116 RECORD := P#DB2.DBX0.0 BYTE 2 When I download program to PLC, the BF LED turns on, but if I remove program and download again, everything works fine. I think the problem is caused by the program, could you give me suggestion? Best regards, Marcus
Alumi Posts: 23 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on