Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

HSC How to setup

Created by: JLJ at: 4/25/2010 3:35 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

4/25/2010 3:35 PM	Rate (0)
JLJ Posts: 6 Rating: (0)	Hej Forum I am new to s7 1200. I have a encoder with A and B and Z channel I can't figure out how to setup a HSC for that. I can read the manual but i have troublewhen i will program i in step7 basic. I hope anyone has a brighter lamp than mine!!! Jens
JLJ Posts: 6 Rating: (0)
Suggestion To thank

4/26/2010 4:48 PM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 11/29/2023 Posts: 4277 Rating: (1377)	Hi, 90% of the the task is to configure in the "device configuration" the properties of the CPU concerning the HSC. After that you can read de input value (e.g. ID1000) as a Dint value in you program. There is ablock CTRL_HSC, but it is used to control the HSC (e.g. reset) in the user program.
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank

4/28/2010 2:06 PM	Rate (0)
tokzu23 Posts: 17 Rating: (3)	Hello, Here is a FAQ regarding the HSC http://support.automation.siemens.com/WW/view/de/41127453 it is very helpful
tokzu23 Posts: 17 Rating: (3)
Suggestion To thank

4/30/2010 2:37 PM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 11/23/2023 Posts: 2683 Rating: (135)	Thread closed, because question is already published in the following thread High speed Counter. Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on