Navigation

HSC INTERUPT

Created by: Chili at: 9/26/2012 4:46 PM (1 Replies)

9/26/2012 4:46 PM	Rate (0)
Chili Posts: 23 Rating: (0)	I am using a SEW Frequency driver to control an AC Geared Motor.There is a incremental encoder on the High Speed Counter 1.I would like an example where an output changes from 1 to 0, when the hardware interrupt picks up that CV = RV.For example if you want to stop the motor at 1000mm, set RV = 1000.I have achieved this by slowing down the motor before the RV value, and not using interrupts, but this slows down the process. CAN ANYONE HELP WITH THE EXAMPLE............
Chili Posts: 23 Rating: (0)	Last edited by: Chili at: 9/26/2012 5:02 PM
Suggestion To thank Quote Answer

9/26/2012 4:54 PM	Rate (0)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 1/21/2025 Posts: 15549 Rating: (2467)	Chili I am using a SEW Frequency driver to control an AC Geared Motor.There is a incremental encoder on the High Speed Counter 1.I would like an example where an output changes from 1 to 0, when the hardware interrupt picks up that CV = RV.For example if you want to stop the motor at 1000mm, set RV = 1000.I have achieved this by slowing down the motor before the RV value, and not using interrupts, but this slows down the process. CAN ANYONE HELP WITH THE EXAMPLE............ Maybe this thread can help develop an example: /tf/WW/en/Posts/80695#top See the last couple of posts to see how it applies to your project problem.
	science guy
Suggestion To thank Quote Answer