Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

HT2 / Handwheel / 840d sl / How to enable??

Created by: leszkoo at: 10/5/2013 11:42 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

10/5/2013 11:42 PM	Rate (0)
leszkoo Experienced Member Joined: 9/13/2010 Last visit: 11/6/2024 Posts: 30 Rating: (1)	Dear All, In my system I've got HT2 pendant. I managed to establish communication with the NC; control HT2 display, pushbuttons and LEDs. Using HT2 pushbuttons I can jog axes. The next step is to enable handwheel, but I don't know how to do that. Could you give some advices how to that ?? Thank you in advance.

Suggestion To thank Quote Answer

10/7/2013 10:28 AM	Rate (0)
pierre_g Posts: 67 Rating: (5)	Hello, Is the handwheel OK ? Have you check in DB10.DBB68 for HW1 or DB10.DBB69 for HW2 ? You have to activate DB3x.dbx4.0 HW1 or DB3x.dbx4.1 for HW2. Pierre
pierre_g Posts: 67 Rating: (5)
Suggestion To thank Quote Answer

10/7/2013 1:55 PM	Rate (0)
leszkoo Experienced Member Joined: 9/13/2010 Last visit: 11/6/2024 Posts: 30 Rating: (1)	Hi, DBB68/DB69 are zero. In this DB all fields are false/zero.

Suggestion To thank Quote Answer

10/7/2013 2:54 PM	Rate (0)
pierre_g Posts: 67 Rating: (5)	Hello, When you move handwheel DB68/69 stay 0 ? You need to configure FB1 in OB100. BHG :=5 BHGIn:= P# M300.0 BHGOut:=P# M300.1 BHGRecGDNo:= 10 Dip switch position PN box. Check MD11350 $MN_HANDWHEEL_SEGMENT[0] = 7 MD11351 $MN_HANDWHEEL_MODULE[0]=1 Look at manual Operator composant and networking. Pierre
pierre_g Posts: 67 Rating: (5)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on