Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

HW modules diagnostics

Created by: cskcsk at: 1/7/2010 9:35 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

1/7/2010 9:35 AM	Rate (0)
cskcsk Posts: 5 Rating: (0)	As I see many modules cann't be configured to force OB82 diagnostic interruption (DI, DO f.e.). But may be ability exists in STEP7 to require directly the simlest diagnostic information from that and all another modules: correct or incorrect? It is a maximum information I would like to get from HW modules. This is concerned inside ET200S modules also. Thanks.
cskcsk Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

1/8/2010 6:44 AM	Rate (0)
Ayman Elotaify Platinum Expert Joined: 5/28/2008 Last visit: 1/2/2025 Posts: 4518 Rating: (841)	Dear cskcsk, Please check the bellow FAQs: How can you have system error messages from a SIMATIC S7-300 / 400 displayed in WinCC flexible? How can you report S7 system errors in WinCC? Regards,
	Ayman Elotaify
Suggestion To thank Quote Answer

1/8/2010 11:46 AM	Rate (0)
cskcsk Posts: 5 Rating: (0)	Ayman Elotaify WinCC Thank you but we do not use WinCC. Moreover, the diagnostic data are needed to process errors automatically (to switch equipment to safe state and eliminate some actions). Now I study ability to use SFC 51 to do that processing. Does exist clear examples of using SFC51 in STEP7 helps or manuals? Give me references if any. Thanks.
cskcsk Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

1/8/2010 2:44 PM	Rate (0)
umencho Diamond Member Joined: 3/21/2006 Last visit: 1/14/2025 Posts: 10239 Rating: (1182)	cskcsk ....Does exist clear examples of using SFC51 in STEP7 helps or manuals?... Look at How do you read out the operating state and status of an H system?and How can you read out the serial number of the MMC? Hope these FAQs will help. Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on