Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Hydroranger 200

Created by: stewarthill at: 5/12/2009 12:40 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

5/12/2009 12:40 PM	Rate (0)
stewarthill Posts: 1 Rating: (0)	Hydroranger 200set up to display volume. Message on screen "ERROR tb:4". Have checked all suggestions in the common problems chart but error persists. Does anyone have any suggestions as to how to clear this problem
stewarthill Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

5/15/2009 8:28 AM	Rate (0)
SonicRanger Posts: 151 Rating: (8)	Hi stewarthill, At startup, wait until the hydro has taken its first shots. When the message is after 10 seconds still in the display, then there's a real error on terminal block 4, so that's one of your transducer inputs. Check if the wiring is OK. Black = +, White = -, shield to shield connection. If this is a replacement from old multiranger to new hydroranger 200, and the sensor cable was extended with coax, use the 0,1 uF capacitor which is delivered with the hydroranger as described in the manual. This error can also appear when the transducer is broken, especially when the temp. sensor fails.Has the transducer suffered a temperature which was above specs? Best Regards, SonicRanger.
SonicRanger Posts: 151 Rating: (8)
Suggestion To thank Quote Answer

2/1/2018 1:40 PM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 11/28/2023 Posts: 7580 Rating: (154)	New question published by damdam77550 is split to a separate thread with the subject Hydroranger problem. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on