Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

I have all the inputs to FC105 entered properly, but the PIW256 is not accepted as the input type

Created by: Kevlar at: 11/4/2011 8:02 PM (4 Replies)

Rating (1)

Thanks 1

5 Entries

11/4/2011 8:02 PM	Rate (0)
Kevlar Posts: 8 Rating: (0)	I have all the inputs to FC105 entered properly, but the PIW256 is not accepted as the input type. Any suggestions? With Thanks. Please see attached. Attachment FC105 SCALE.jpg (119 Downloads)
Kevlar Posts: 8 Rating: (0)	Last edited by: O_Moderator at: 11/7/2011 9:16 AM new subject after splitting from /tf/WW/en/Posts/60246#top
Suggestion To thank Quote Answer

11/4/2011 8:14 PM	Rate (0)
Marcjan Platinum Expert Joined: 4/22/2010 Last visit: 12/15/2022 Posts: 5697 Rating: (707)	hello, Just move the piw to a MW and it will work, see attachment. Not sure about the reason off this problem, if i remember well it has a relation with the symbolic addressing. Regards, Marcjan Attachment piw.JPG (111 Downloads)
	Last edited by: Marcjan at: 11/4/2011 8:17 PM need a new keyboaed :-( Last edited by: Marcjan at: 11/4/2011 8:15 PM Problem solved? Please let us know! Please no technical questions by PM, use the forum sections for your questions.
Suggestion To thank Quote Answer

11/4/2011 9:01 PM	Rate (0)
hdhosseini Diamond Expert Joined: 1/28/2009 Last visit: 6/10/2023 Posts: 6807 Rating: (1346)	Kevlar I have all the inputs to FC105 entered properly, but the PIW256 is not accepted as the input type. Any suggestions? With Thanks. Please see attached. Dear Kevlar , Check your language selected in your SIMATIC Manager. If it is German (as shown in attachment) change it to English.It is only a possibility! Best regards Attachment LANGUAGE.jpg (65 Downloads)
	Demo Channel on Youtube
Suggestion To thank Quote Answer

11/7/2011 1:16 PM	Rate (1)
Ton Verra Gold Member Joined: 4/20/2007 Last visit: 5/4/2023 Posts: 722 Rating: (40)	Just make sure your PIW adress is declared as a INT data type in your Symbol Table. Have made that mistake a couple of times myself :-)

Suggestion To thank Quote Answer

11/10/2011 9:57 AM	Rate (0)
Marcjan Platinum Expert Joined: 4/22/2010 Last visit: 12/15/2022 Posts: 5697 Rating: (707)	Hello, That was the problem indeed , thanks for refreshing my mind It's easy to make that mistake because Step7 automaticly fills in the data type word Regards, Marcjan
	Problem solved? Please let us know! Please no technical questions by PM, use the forum sections for your questions.
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Ton Verra

|

Share this page:

Share this page on...

Follow us on