Navigation

I have no access to see or configure the SIPROTEC

Created by: ronbuciu at: 4/11/2012 10:38 AM (1 Replies)

4/11/2012 10:38 AM	Rate (0)
ronbuciu Regular Member Joined: 3/5/2012 Last visit: 12/4/2023 Posts: 1 Rating: (0)	Hello, I havethe nextproblem: SICAM reads parametersfrom SIPROTEC by PROFIBUS protocol. I have no access to see or configure the SIPROTEC. The SIPROTEC was configured by Siemens Romania. Ihave access only on the SICAM project that was developed by a colleague that is not available now. There are 4 consumers, 2 of 250 KW and 2 of 500 KW. The powerdisplaying by SICAM for the two 2 250KW is correct, the power of the other 2 consumers of 500 KW is correct until the value 250 KW and wrong above 250 KW, the value read by SICAM being -32768 (8000 H).It seems to be o scale configuration problem. My question is where is wrong: in SIPROTEC or in SICAM. Tank you!
	Last edited by: O_Moderator at: 4/11/2012 12:51 PM new subject after splitting from /tf/WW/en/Posts/65778#top
Suggestion To thank Quote Answer

4/18/2012 12:57 PM	Rate (0)
Mike J Platinum Expert Joined: 10/9/2007 Last visit: 12/6/2023 Posts: 1234 Rating: (115)	Hi Which Sicam do you have? Are you using Profibus FMS or DP? Mike
	Energy Automation products: Sicam, Siprotec, Digsi
Suggestion To thank Quote Answer