Getting IO device failure on S7-1511 setup as iDevice with Microbox 1507S CPU. Seems like everything is setup correctly, but data is not transferring and getting this error. Attached are pics of the setup. Any ideas?

Hello,

Perhaps you can give some more information.

About the data you want to transfer from CPU1511-1  (I-device communication)

Best regards,

Wizard

The transfer areas are Q0->I0 32 bytes and then back as I0<-Q0 32 bytes

Try downloading the hardware configuration to both devices using technique similar to the posted image.

sstoner

Getting IO device failure on S7-1511 setup as iDevice with Microbox 1507S CPU. Seems like everything is setup correctly, but data is not transferring and getting this error. Attached are pics of the setup. Any ideas?

huggy_d1

On the Granger_SCS PC, for the profinet adapter connected in the network view, did you set the General Properties -> interface assignment to SIMATIC PC Station?  Or did you leave it at the default value and only windows can use it?

 X1 is assigned to SIMATIC PC Station. This is the port that I connect to the CPU for online/download/monitoring etc.

X2 is assigned to the CPU-1507S which is the network that the iDevice is connected to.

Another oddity... I have an HMI pulling data from the CPU-1507S, but cannot pull any tags from the S7-1511 (iDevice). I have Access Level set to Full and Permit access with Put/Get, but is there anything else along those lines I should look at? I can go online and download/monitor the S7-1511 but doesn't seem to want to let anything else talk to it.