Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

IM154-8 CPU upload issue

Created by: vipz at: 3/19/2014 12:45 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

3/19/2014 12:45 PM	Rate (0)
vipz Gold Member Joined: 9/2/2012 Last visit: 1/16/2025 Posts: 711 Rating: (30)	Hai, One of our customer placeIM154-8 CPU is installed. when we tried to do upload it is showing error as (D241) The function is not permitted in the current protection level. see the attached screen shot. But there is no protection present in project (cross checked in original backup). This error is not present everytime, but some times happening. But if we hold the run-stop selector switch from run position towards up (normal run-stop-mres positions only present on cpu) , there is no error . can do upload without any error. same thing is happening for monitoring/download also. Is it because of hardware issue ? Attachment IM154-8 CPU.jpg (94 Downloads)
	With Best Regards VIPZ
Suggestion To thank Quote Answer

3/20/2014 12:40 PM	Rate (0)
Pittiplatsch Posts: 1368 Rating: (128)	Hello vipz, SIMATIC IEPG Help Service needs to be started. Look at the taskmanager, if the service is started. Otherwise you can start it manually. ThisServiceuse theRFC1006 – Port,which is necessary for the communikation STEP7 ↔ CPU. Good luck.
Pittiplatsch Posts: 1368 Rating: (128)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users vipz

3/20/2014 5:25 PM	Rate (0)
vipz Gold Member Joined: 9/2/2012 Last visit: 1/16/2025 Posts: 711 Rating: (30)	Ok. now am not at site . when am going next time, will try this.
	With Best Regards VIPZ
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on