Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Image Pcu50

Created by: emil2 at: 11/17/2010 6:25 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

11/17/2010 6:25 PM	Rate (0)
emil2 Posts: 11 Rating: (0)	Hi, We have 8 pcs of mmc103 and pcu50. They have worked 10 years in 3-shift. When we start to make backup with acronis softwear we found that the nc-program in wks-direktorywas notpresent in the imagefile, but nc-program who was not loaded in workmemory was there. My question is, when the program is loaded to workmemory is it deletedon the harddisk? We change the old harddisk with a 32 gb Transcend ssd with success. Probably the fastest Siemens 840d in the world. BR emil2
emil2 Posts: 11 Rating: (0)
Suggestion To thank Quote Answer

11/17/2010 6:40 PM	Rate (0)
Pee El Sea Gold Member Joined: 1/19/2008 Last visit: 10/2/2024 Posts: 992 Rating: (63)	Hi, Yes is the answer The only time the program is both in the NC and on the disk is if an image has been loaded onto the disk with the program on it and it had previously been loaded into the NC. When it is in both places the system shows the loaded symbol with exclamation marks. Pee

Suggestion To thank Quote Answer

11/18/2010 6:23 AM	Rate (0)
emil2 Posts: 11 Rating: (0)	Hi again, Is there more data to unload from memory before we make a backup (plc tooldata)? BR emil2
emil2 Posts: 11 Rating: (0)
Suggestion To thank Quote Answer

11/18/2010 9:15 AM	Rate (0)
Pee El Sea Gold Member Joined: 1/19/2008 Last visit: 10/2/2024 Posts: 992 Rating: (63)	HI, No, We would normally make an NC archive file to bachup the everything in NC and a PLC archive file to backup the PLC. All you are looking for from a PCU back up is to get the HMI up and running. Pee

Suggestion To thank Quote Answer

11/18/2010 8:51 PM	Rate (0)
emil2 Posts: 11 Rating: (0)	Thank you Pee for the quick answers. /emil2
emil2 Posts: 11 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on