Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

IMI151-8 shows red SF and BF

Created by: przewik at: 9/10/2019 10:03 PM (3 Replies)

Rating (0)

Thanks 1

4 Entries

9/10/2019 10:03 PM	Rate (0)
przewik Posts: 4 Rating: (0)	Hello, i have problem with communiation to the PLC from PG station(PC). At first, i had problem with connection between PLC(has 3 eth ports) and inverter. Inverter was broken and i got it repaired. Then I tried to establish connection, but I only had an error(attachment hwh3,hwh2, hwhh5). I tried to change the ip addresses, set the slave-master etc. When i changed ip address of the PLC and try to download Hardware, downloading stop with and error and then i only have BF and SF led. I can not connect even to the PLC(hw1). I can not see any accesible nodes(when i click update i can see nothing). Could someone help me? Attachment hwh3.jpg (11 Downloads)
przewik Posts: 4 Rating: (0)	Last edited by: przewik at: 09/10/2019 22:04:18
Suggestion To thank Quote Answer

9/10/2019 10:06 PM	Rate (0)
przewik Posts: 4 Rating: (0)	Attachment hw1.jpg (13 Downloads)
przewik Posts: 4 Rating: (0)	Last edited by: przewik at: 09/10/2019 22:07:07
Suggestion To thank Quote Answer

9/11/2019 7:59 AM	Rate (0)
Duris_I Diamond Member Joined: 4/28/2015 Last visit: 6/1/2023 Posts: 9530 Rating: (746)	Hello, for future I recommend zip more pictures and atach zip file. For problem, maybe you can use some MMC (if now existing on CPU) and prepare another one with same cfg, plug inside CPU and check functionality. Maybe existing MMC is corrupted after some problems. In next time pls give us more infos about your existing HW, also real pictures from CPU about LEDs f.ex.
	With best regards... Ivan Duris VId: OMICO
Suggestion To thank Quote Answer

9/12/2019 7:35 PM	Rate (0)
przewik Posts: 4 Rating: (0)	I have resolved the problem. I have used a profinet manager, then changed ip addresses. Thank you!
przewik Posts: 4 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Duris_I

|

Share this page:

Share this page on...

Follow us on