Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Inverter and Conveyor

Created by: sbartoc at: 6/9/2016 2:48 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

6/9/2016 2:48 PM	Rate (0)
sbartoc Bronze Member Joined: 3/3/2014 Last visit: 10/11/2024 Posts: 234 Rating: (9)	Hello everybody, Is it possible to start a conveyor just connecting his Inverter and giving power? I mean, I want to check if the phases are correct without the PLC program. How can I do it? The configuration should be CPU 315 2 DP and G120 the inverter
	Last edited by: sbartoc at: 6/9/2016 2:52:09 PM Last edited by: sbartoc at: 6/9/2016 4:00:27 PM
Suggestion To thank Quote Answer

6/9/2016 4:39 PM	Rate (0)
PISCEAN 2010 Diamond Member Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating: (877)	Yes possible. Use BOP or configure DI default setting 1.

Suggestion To thank Quote Answer

6/9/2016 4:45 PM	Rate (0)
sbartoc Bronze Member Joined: 3/3/2014 Last visit: 10/11/2024 Posts: 234 Rating: (9)	Hi @Piscean 2010 Directly on Inverter Panel?
	Last edited by: sbartoc at: 6/9/2016 4:48:27 PM
Suggestion To thank Quote Answer

6/9/2016 4:58 PM	Rate (0)
PISCEAN 2010 Diamond Member Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating: (877)	Hello, You need to enter motor data correctly & from BOP of inverter or use DI on terminals & can run motor from inverter without PLC control.
	Last edited by: PISCEAN 2010 at: 6/9/2016 5:01:53 PM
Suggestion To thank Quote Answer

6/9/2016 5:01 PM	Rate (0)
sbartoc Bronze Member Joined: 3/3/2014 Last visit: 10/11/2024 Posts: 234 Rating: (9)	OK, So I need to insert the parameters in the BOP of the inverter and then I can try the conveyor. Which are the parameters? Frequency (50Hz) , then ?

Suggestion To thank Quote Answer

6/9/2016 5:07 PM	Rate (0)
PISCEAN 2010 Diamond Member Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating: (877)	Please visit this Installation and parametrization of a SINAMICS G120 (Videos).

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on