Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Is it possible to use 12pcs (or more than 3) of 16xDI NAMUR 7TH00 cards in ET200M? Simatic selection tool says it is not, HW Config has no problem?

Created by: andrej5 at: 3/30/2011 10:04 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

3/30/2011 10:04 AM	Rate (0)
andrej5 Regular Member Joined: 2/24/2009 Last visit: 9/23/2019 Posts: 26 Rating: (0)	I try to make an offer for customer and I want to use there ET200M with NAMUR 321-7TH-0AB0 DI cards, but when I try to insert fourth card, SIMATIC Selection Tool says: "You cannot insert this module, otherwise the parameter quantity of 70 would be exceeded" I think, it is somehow connected with "Parameter/station" Bytes, which are 234Bytes long from 244 total. What does those "parameters/station" mean, and why can I insert those modules in Step7 HW Config without problems? Attachment et200m.JPG (51 Downloads)

Suggestion To thank Quote Answer

3/30/2011 10:05 AM	Rate (0)
andrej5 Regular Member Joined: 2/24/2009 Last visit: 9/23/2019 Posts: 26 Rating: (0)	Parameters/station snapshot Attachment et200m4.JPG (48 Downloads)

Suggestion To thank Quote Answer

3/30/2011 10:07 AM	Rate (0)
andrej5 Regular Member Joined: 2/24/2009 Last visit: 9/23/2019 Posts: 26 Rating: (0)	Simatic selection tool settings...... Attachment et200m3.JPG (40 Downloads)

Suggestion To thank Quote Answer

3/30/2011 10:09 AM	Rate (0)
andrej5 Regular Member Joined: 2/24/2009 Last visit: 9/23/2019 Posts: 26 Rating: (0)	HW config has no problem? Attachment et200m2.JPG (43 Downloads)

Suggestion To thank Quote Answer

3/30/2011 2:38 PM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 6/7/2023 Posts: 12036 Rating: (2595)	Hello andrej; I have not worked with this type of module, but in my experience the HWConfig editor is generally considered the better judge of configuration problems with Siemens equipment. Sometimes the configurators can provide information that is not always up to date. I would suggest you bring this to the attention of Siemens' support staff, they would be the ones tovalidate if there are parameter limitations on the Namur input modules. To contact them, open a Support request (there is a link at the top right of this webpage, under Contacts) and fill in the application. Hope this helps, Daniel Chartier

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on