Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Issue in Drive commissioning using Communication and Standard IO

Created by: viren.vadgama at: 6/8/2017 8:25 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/8/2017 8:25 AM	Rate (0)
viren.vadgama Advanced Member Joined: 9/23/2015 Last visit: 3/24/2023 Posts: 48 Rating: (0)	Hello everyone, I have G120 Drive with CU250S - 2 Card. My application is control drive with PLC 1200 series using Profinet communication. It is done drive work properly. But I will plan to set second option for in case communication fail that time drive will be running using IO on board drive. I have no idea how to set this second option.

Suggestion To thank Quote Answer

6/8/2017 9:19 AM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 12/8/2023 Posts: 5725 Rating: (771)	Hello, I would recommend to use the command data set function of the SINAMICS. You can find further information in CU250S-2 operating instructions manual section 6.2.12 https://support.industry.siemens.com/cs/ww/de/view/109482997/en?dl=en
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

6/13/2017 11:10 AM	Rate (0)
viren.vadgama Advanced Member Joined: 9/23/2015 Last visit: 3/24/2023 Posts: 48 Rating: (0)	Thank you so much sir. Trial successfully completed.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_G

Follow us on