k@ustubhydande89

Hi all,

This is Kaustubh,

M using S7 1200 CM1241  RS232 module for communication with epson printer,

The printer communication settings are like this..

Baud-9600bps,

Parity-none,

Data bits-8 bits,

Stop bits - NA,

Parallel I/F Bidirectional mode-On

Packet Mode - Auto

We previously had a succefull print from Siemens Smart ST30 (from CM01 module in free port mode)plc on this printer

CAN SUMBDY PLZ TEL ME HOE TO DO THIS PRINT FROM CM1241 OF S7 1200.

I tried instruction "port_config"

and after this "send_ptp"

but printer is not even moving.

is der any method by which should i give command & texts for printing on printer.

Please help.....!

Thanks.

------------------------------------------------------------------------------------------
Split from S7-1200 CM 1241 ASCII communication with Hyperterminal PC .

 Hi,

Hope you have got the solution. I am also searching for the same solution. Please help me. If possible send me your project or some pictures so I can able to solve my issue as well

Best Regards...Jignesh

------------------------------------------------------------------------------------------
Split from How can make print from CM1241 of S7 1200?.

Closed cause question posted twice.

The second thread with the subject Not able to print single word from PLC / CM1241 is published within the conference Communication / Networks.

Best regards
Jen_Moderator