Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

JOG mode not working

Created by: A_Ibrahem at: 8/29/2013 7:10 PM (2 Replies)

Rating (1)

Thanks 3

3 Entries

8/29/2013 7:10 PM	Rate (0)
A_Ibrahem Posts: 2 Rating: (0)	Dear Team, I have a 840D machine with : NCU 572.3 (6FC5357-0BB22-0AE0) and MMC103 version B (6FC5210-0da20-2AA1) , MCP (6FC5203-0AD10-0AA0 2 axis and 2 spindles problem is not able to JOG any axis ,if i select jog mode and try to select X-axis the button lights on and off immediately when i remove my finger and if i try to select Z-axis the button flashes and turns off when i remove my finger also. have short video of the issue but cant upload its around 10 MB attached NC & PLC . Kindly advise what is wrong ? Thanks Ahmed Attachment Attachment.zip (83 Downloads)
A_Ibrahem Posts: 2 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users APC Tech Team

9/16/2013 9:09 AM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	Hi, Is there any alarm on screen?? Canyou tell then what axis is selected on the MCP.And als test us the PLC backup in step7 formate to check is there any interlock on the System.
	Regards, ŠΜS
Suggestion To thank Quote Answer

9/16/2013 12:44 PM	Rate (1)
Ahmed Tawfik Posts: 5 Rating: (1)	Hello SMS, Actually problem solved already ,it was the MCP gone crazy i changed it and issue is gone. thank you for reply. BR, Ahmed
Ahmed Tawfik Posts: 5 Rating: (1)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users ŠΜS APC Tech Team

|

Share this page:

Share this page on...

Follow us on