Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

KTP600 button tag NOT work with PLC TAG

Created by: microic1 at: 4/28/2013 7:55 PM (6 Replies)

Rating (0)

Thanks 0

7 Entries

4/28/2013 7:55 PM	Rate (0)
microic1 Posts: 13 Rating: (0)	Hi to all, PLC S7-1200 + KTP600 + WINCC BASIC SP2 Update 4 + STEP7 Professional V11SP2 Update 4 + TIA v 11 SP2 Update 4 New BUTTON and NEW tag (boolean) is created within PLC and within KTP600-EVENT - setbit while pressed, but PLC not receive it. I would like to add RESET button once when condition appear within PLC program. Button appear once signal on PLC changed, but once same button is pressed PLC TAG not change. I have other buttons working withot any problem, but this one is last edited. I did try reset PLC and KTP600, compile all on both unit but without sucess. Any answer will be appreciated.
microic1 Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

4/29/2013 6:45 AM	Rate (0)
eray1907 Posts: 14 Rating: (0)	Try with "invert bit"
eray1907 Posts: 14 Rating: (0)
Suggestion To thank Quote Answer

4/29/2013 9:58 AM	Rate (0)
microic1 Posts: 13 Rating: (0)	zhanks for answer, I did, but without success, I try all options and SETBIT, RESETBIT. Any other suggestions?
microic1 Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

4/29/2013 10:14 AM	Rate (0)
microic1 Posts: 13 Rating: (0)	Thanks for answer, I did but no success. I also try invertbit, setbit, resetbit. No one work. Any other suggestion? Thanks
microic1 Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

4/30/2013 1:26 PM	Rate (0)
Tweety Posts: 3037 Rating: (192)	Hello, Is the connection to your PLC constructed? You can see it in a systemmessage in the messageview. You use the update 5 for WinCC V11 SP2. http://support.automation.siemens.com/WW/view/de/58112582 Tweety
Tweety Posts: 3037 Rating: (192)
Suggestion To thank Quote Answer

5/5/2013 11:38 PM	Rate (0)
microic1 Posts: 13 Rating: (0)	Hi, i don't understand what you mean with "constructed"! After I reset several times PLC to Factory reset, unit start to work, but I am still not sure that is real solution, because it was reset befor. I will check with bew unit once arrive. Thanks for answer, Rgds, Damir
microic1 Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

5/7/2013 12:17 PM	Rate (0)
Tweety Posts: 3037 Rating: (192)	microic1 Hi, i don't understand what you mean with "constructed"! I mean whether the connection from plc to KTP established? Tweety
Tweety Posts: 3037 Rating: (192)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Adv Picture Controls

Follow us on