Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

LOGO SOFT COMFORT V8 NETWORK SIMULATION

Created by: jin11111 at: 10/12/2014 8:59 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/12/2014 8:59 PM	Rate (0)
jin11111 Posts: 1 Rating: (0)	Hi, When simulating two or more LOGO OB8 simple network programs (by using the green blocks), the outputs sometimes turn on, sometimes don't, followed the procedures but the network simulation does not work properly, kindly ask if you had the same problem, regards
jin11111 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

10/13/2014 8:26 AM	Rate (0)
Helmut_13 Posts: 2930 Rating: (432)	No, I don't have the same problem. Check you network configuration. In most cases here is the problem. Regards Helmut
Helmut_13 Posts: 2930 Rating: (432)
Suggestion To thank Quote Answer

10/13/2014 9:57 AM	Rate (0)
Croppy Bronze Member Joined: 9/3/2011 Last visit: 6/11/2021 Posts: 12 Rating: (1)	When I was using a HMI screen I found under the Ethernet connection setting I need to set keep alive. And put the time down to 1s. This gave me an instant response when turning on an output. Hope this helps.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on