Logo Soft Comfort v8 Set clock failing

but its keep failing. "Clock configuration not supported" and "failed to load the panel" in Soft Comfort v8

i tried in Soft Comfort v6 it worked without any problems.

Any surgestions to get it to work ind Soft Comfort v8?

Mark

Hello Mark,

I am not sure about 0BA2 but  "Clock configuration not supported" clearly indicates that the Logo is in conflit of  the computer's hours format.  Zero to 12 or Zero to 24.  Try to change one to another format. May be it works.

Forni

Hello Mark,

I am not sure about 0BA2 but  "Clock configuration not supported" clearly indicates that the Logo is in conflit of  the computer's hours format.  Zero to 12 or Zero to 24.  Try to change one to another format. May be it works.

Hi Forni

i´ll try that tomorrow. i´ll report back. 

but i think the problem is Logo Soft Comfort v8. because it works with the same computer in Logo Soft Comfort v6. 

I have the same problem with Log0osoft 8.3 and a OBa2 with relays . both the clocks are 24 Hour. if i use old logosoft it works .

obviously logosoft 8.3 doesn't fully support the old logos fully ?

Hi,

try to set the hardware in LSC (0BA2) to your version first. Then set clock and time.

Hoped this helps.